ATTACHMENT INSTRUCTIONS FOR FLUSH MOUNT No. 4612 (FOR WALL OR CEILING)

• UNSCREW THE 3 GLASS HOLDERS (J) AND PUT THE GLASS (I) ASIDE.
• ATTACH THE CROSS BAR (B) TO THE JUNCTION BOX (A) (NOT SUPPLIED).
• INSERT THE 2 WIRE SOCKETS THROUGH THE HOLES IN THE CANOPY (D).
• CONNECT THE SOCKET WIRE TO THE ELECTRICAL WIRES IN THE JUNCTION BOX (A) WITH WIRE NUTS (NOT SUPPLIED).
• SCREW THE NIPPLE (E) INTO THE CROSS BAR (B) 1/4 OF THE WAY.
• INSERT THE LAMP PLATE (F) ONTO THE NIPPLE (E) OVER THE CANOPY (D) AND SCREW THE NIPPLE COVER (G) ONTO THE NIPPLE (E) (MAKE SURE ALL WIRES ARE UNDER THE CANOPY (D) AND SECURED).
• INSERT THE 200W HALOGEN BULB (H) IN BETWEEN THE SOCKETS (DO THIS BY PUSHING ONE SIDE OF THE BULB INTO ONE SOCKET FIRST, THEN CONTINUE TO DO THE SAME FOR THE OTHER SIDE. (THIS TYPE OF BULB USE SOCKET THAT MADE OUT OF 2 PARTS).
• NEVER TOUCH THE BULB WITH BARE HANDS ALWAYS HOLD IT WITH CLEAN PAPER. OIL LEFT BY YOUR FINGERPRINT MAY CAUSE THE THE BULB TO EXPLODE WHEN HEATED. FINGER MARKS LEFT ON THE BULB SHOULD BE WIPED OFF WITH ALCOHOL. CAUTION: HALOGEN BULBS PRODUCE HIGH INTENSITY HEAT.
• REATTACH THE GLASS (I) TO THE LAMP PLATE (F) WITH THE 3 GLASS HOLDERS (J).
• YOUR NEW HALOGEN LAMP MAY "SMOKE" WHEN FIRST USED. IT IS NORMAL FOR THE BULB TO BURN OUT ALL EXCESS MATERIAL LEFT ON IT FOR THE FIRST FEW MINUTES OF OPERATION.